Skip to content
Elmwood Park Drywall Repair

Drywall Hole and Corner Repair in Elmwood Park, IL

Is one hole in the wall worth a call? Yes, if it is bigger than a coin or sits on a corner. Drywall hole and corner repair in Elmwood Park covers the damage everyday life leaves: a doorknob that went through, a TV mount pulled out, a corner chipped down to the metal. Small jobs are welcome, and pairing a few of them makes the visit worth more.

1. Which patch a given hole calls for

What kind of patch does your hole need? Here is how the size usually decides it:

  • Up to about an inch: anchor holes and dents. Filled with setting compound, two coats, then sanded flat.
  • Up to about six inches: a doorknob hole. A backing strip or a mesh-backed patch goes in behind the opening, then three coats over it.
  • Bigger than that: the hole is cut square to the nearest studs, a new piece of drywall is screwed in, and the seams are taped and coated like new work.

If the hole is in plaster rather than drywall, the same idea applies, but the insert has to be shimmed to plaster depth. The plaster patching page covers that version.

2. Broken outside corners

Why does the corner look like it was chewed? Outside corners are protected by a strip of metal or paper-faced bead under the compound. A hard knock dents the bead, the compound over it cracks off, and now the metal shows. Painting over it will not hold.

The fix: cut out the dented length of bead, fasten a new piece plumb and straight, and float it out with compound on both faces of the corner. In hallways and stairways, where furniture and moving boxes hit, a paper-faced bead stands up to dings well. Elmwood Park counted 24,521 residents in the 2020 census, and many live in apartment buildings where corners like these are among the first things checked at a move-out walk-through.

Five wall textures drawn side by side: smooth, orange peel, knockdown, skip trowel and popcorn.SmoothOrange peelKnockdownSkip trowelPopcorn
The five finishes you are most likely to find on a wall or ceiling. Older plaster is usually smooth; textured finishes turn up more in later drywall rooms.

3. Getting the texture to blend in

Will the patch look different from the wall around it? Not if the texture is copied well. Walls in houses built before 1960, which is roughly six in ten in the village, are mostly smooth plaster or a light sand finish. Later drywall rooms are more likely to have orange peel or knockdown. Here is how each one is reproduced:

  • Smooth: feathered wide and sanded until a light held flat against it shows no edge.
  • Orange peel: sprayed in light passes and checked against the wall at arm's length.
  • Knockdown: spattered, left to set a moment, then knocked flat with a broad knife.
  • Skip trowel: applied by hand in short arcs that copy the rhythm of the old work.
  • Popcorn: a patch spray for ceilings, usually followed by paint.

The final step is primer, then paint. Unprimed compound absorbs paint differently from the rest of the wall, and that alone explains most patches that still show.

4. Hole and corner questions

Is a single small hole too small a job?

No. A single hole is a normal request. If you have a few small things around the house, listing them all when you call lets them be handled in the same visit.

Can you match a texture I cannot name?

Usually. A photo up close and one at an angle helps the pro see the pattern before the visit, and a test spot is done before the patch itself.

How long until I can hang the TV back up?

Once the patch has dried, been primed and painted, which for a mount hole is usually within a couple of visits. New anchors should go into a stud or into fresh board, not into the patch edge.

Got a wall like this?

Describe it on the phone, or send the request form, and a quote comes before any work.

Call 7 days, 7am–9pm

Call (708) 726-0687

Calling gets you a straight answer on the wall and a visit set up to price it.

Schedule a repair quote Ask about your wall with a photo

View service area list